GLI L4-2.0L Turbo (BPY) (2008)
/Page-1196002.png)
-
Repairs in the area of the airbag or seat belt tensioner should be performed a maximum of 30 cm from the next terminal housing. Together with the
identification via yellow insulating tape, this procedure makes it possible to obtain a quick overview of previously performed repairs.
-
Wires to the deploying units (airbags) have a wire-twisting with a length of lay of 20 mm plusminus 5 in series production. This length of lay is
guaranteed via the norm part numbers for wire pairs in series production and must be observed strictly for the repair lengths of twisted wires.
-
During repair work, wires to deploying units (airbags) must have the same length. When twisting together wires -1 - and - 2 -, length of lay of A =
20 mm plusminus 5 must be strictly observed.
