GLI L4-2.0L Turbo (BPY) (2008)
1
Circlip
‹› Removing and installing --> [ Transmission Housing, Shift Mechanism, Input Shaft, Output Shafts, Differential and Selector Rods ] See:
Transmission Housing, Shift Mechanism, Input Shaft, Output Shafts, Differential and Selector Rods.
2
Transmission housing
3
Circlip
‹› When replacing grooved ball bearing --> [ 4 Grooved ball bearing ] and input shaft --> [ 6 Input shaft ] , determine again --> [ Determining
Circlip ]
4
Grooved ball bearing
‹› Always replace
‹› Pulling off --> [ Pulling Off Grooved Ball Bearing ]
‹› Pressing on --> [ Pressing On Grooved Ball Bearing ]
5
Drive gear for 5th gear
‹› Pressing off --> [ Pressing Off 5th Gear, Gear Wheel ]
‹› Installation position: The surrounding groove - arrow - points toward grooved ball bearing --> [ 4 Grooved ball bearing ]
‹› Pressing on --> [ Pressing On 5th Gear, Gear Wheel ]
6
Input shaft