GLI L4-2.0L Turbo (BPY) (2008)
A Support, e.g. (Kukko 22/1)
B Internal puller 8 to 12 mm, e.g. (Kukko 21/01)
Remove circlip - C - from grooved ball bearing of input shaft/transmission housing as follows:
-
Hold one end of circlip in place using screwdriver - A -.
-
Using a screwdriver - B - pry other end out of groove of grooved ball bearing in direction of- arrow -.
-
By repositioning screwdriver - B -, pry circlip out further.
-
Remove mounting screws - A - for transmission housing at clutch housing.
-
Screw adapter (VW 771/40) into threaded hole of transmission housing.