GLI L4-2.0L Turbo (BPY) (2008)
-
At the same time, 2nd technician lifts input, reverse and output shaft for 5th/6th gear - 3 - together with selector rods out of clutch housing - arrow
B -.
‹› If necessary, differential can be shifted again in clutch housing after lifting shafts.
-
Remove seal for input shaft.
‹› Grooved ball bearing on input shaft must always be replaced --> [ 4 Grooved ball bearing ] See: Input Shaft.
Assembly
‹› Press a new grooved ball bearing onto input shaft --> [ 4 Grooved ball bearing ] See: Input Shaft.
-
Insert input shaft - 1 -, output shaft for 5th/6th gears - 2 - together with selector rod - 3 -, shift fork - 4 - and reverse shaft - 5 -.
-
Insert differential - 1 -.