GLI L4-2.0L Turbo (CCTA) (2008)
Crankshaft Seal Retainer: Service and Repair
Sealing Flange and Dual Mass Flywheel Assembly Overview
Sealing Flange and Dual Mass Flywheel Assembly Overview
1 -
Cylinder block
^
Removing and installing crankshaft.
^
Piston and connecting rod, disassembling and assembling Pistons and Connecting Rod Assembly Overview.
2 -
Fitting pin
3 -
Sealing flange, transmission side
^
With seal
^
Only replaced as complete unit
^
Before installing, remove oil remains from crankshaft journal with a clean cloth
^
Do not oil or grease the sealing lip of oil seal
^
To install, use provided guide sleeve
^
Guide sleeve may only be removed after the sealing flange has been slid onto the crankshaft pin.
^
Removing and installing.
4 -
Bolt
5 -
Intermediate plate
^
Must be located on dowel sleeves
^
Do not damage or bend when doing assembly work
^
Is hooked in at sealing flange
6 -
Bolt
^
For dual mass flywheel
^
Replace
^
60 Nm + an additional 90° (1/4 turn)
7 -
Dual mass flywheel