GLI L4-2.0L Turbo (CCTA) (2008)
-
Lower the engine approximately. 55 mm.
-
Free up the electrical wiring harness - arrow -.
-
Remove the bolt - 1 - and remove the ribbed belt tensioner from the accessory bracket.
Installing
‹› Tightening specifications, refer to --> [ Ribbed Belt Assembly Overview ] See: Drive Belt/Service and Repair/Ribbed Belt Assembly Overview.
‹› Tightening specifications, refer to --> [ Engine and Transmission Mount Assembly Overview ] See: Engine Mount/Service and Repair.
Install in reverse order of removal. When doing this note the following:
-
Insert the ribbed belt tensioner - 1 - into the accessory bracket - 3 - and tighten the bolt - 5 -.