GLI L4-2.0L Turbo (CCTA) (2008)
-
Use test adapter VAS 5570 in order establish the electrical connection between the vehicle and fuel pressure sensor G247 again.
-
Connect vehicle diagnosis tester - 1 - as follows:
-
Connect diagnostic cable - 2 - to Data Link Connector (DLC) in driver footwell.
-
Switch ignition on.
-
On the following screens, select:
Vehicle Self-Diagnosis
01 - Engine Electronics
011 - Measured Values
-
Enter 140 and confirm with Q.
The current value is displayed in field 3, which the fuel pressure sensor G247 reports to the vehicle.
-
Switch digital manometer VAS 6394/1 on by quickly pressing button - A - one time.
NOTE: Holding button - A - for 2 seconds switches on the illumination for 20 seconds.
The digital manometer VAS 6394/1 should display 0 bar; if this is not the case, then press button - C - one time quickly to set it back to zero.