volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Delivery Quantity, Checking|Page 1715 > < Delivery Quantity, Checking|Page 1713
Page 3
background image

-

Connect digital manometer VAS 6394/1 pressure line to adapter VAS 6394/2.

-

Start engine and run at idle speed.

-

Compare the displayed digital manometer VAS 6394/1 pressure with current value of the vehicle diagnostic tester:
-

Pressures may differ from each other up to 5 bar.

CAUTION:
The digital manometer VAS 6394/1 is under high fuel pressure.
-

With the engine running, disconnect the connector from the fuel pressure regulator valve N276. The fuel pressure will drop to
approximately 6 bar.

-

Switch off ignition.

-

Place a rag around the fuel pressure regulator valve G247, then carefully loosen the fuel pressure regulator valve G247 to release the
remaining pressure.

If pressures do not match:

-

Fuel pressure sensor G247 replacing.

If measured value do not match again:

-

Perform a wiring test.

If measured values match:

-

Further testing is found in "Guided Fault Finding".

Delivery Quantity, Checking|Page 1715 > < Delivery Quantity, Checking|Page 1713