volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Delivery Quantity, Checking|Page 1727 > < Delivery Quantity, Checking|Page 1725
Page 8
background image

‹› Pull circlip upward to unlock fuel line

-

Install a fuel pressure gauge with appropriate adapters.

-

Open shut off valve on fuel gauge.

-

Switch ignition on and off repeatedly until fuel pressure stops increasing pressure.

-

Read fuel pressure on the gauge.

‹› Specified value: 3.5 to 6 bar

If specification is exceeded:

-

Check return line between fuel filter and fuel pump for kinks or blockage.

If no malfunction in fuel return line is found:

-

 Pressure relief valve in fuel filter is malfunctioning. 

-

Replace the fuel filter.

If reading was below the specification:

-

 Check fuel pressure at the fuel filter between fuel pump and fuel filter using appropriate adapters

-

 Open shut off valve on gauge and start the engine. Allow to idle. 

-

 Slowly close the pressure gauge shut off and note the fuel pressure. 

‹› Pressure must increase to 6 bar.

When 6 bar is reached: Open shut off tap immediately!

If pressure has increased during test:

-

Fuel pump is OK. Pressure relief valve in fuel filter is malfunctioning. 

-

Replace the fuel filter.

If pressure did not increase:

-

 Fuel pump is faulty

-

Replace the fuel pump.

Final procedures

Delivery Quantity, Checking|Page 1727 > < Delivery Quantity, Checking|Page 1725