GLI L4-2.0L Turbo (CCTA) (2008)
7
Oil Filter, 20 Nm
‹› See notes --> [ If metal shavings or a large quantity of small metal particles are found when repairing an engine, this could indicate that the
crankshaft and/or connecting rod bearings are damaged. To prevent further damage, perform the following steps after the repair: ] See: Engine,
Cooling and Exhaust/Engine/Engine Lubrication/Description and Operation.
‹› Remove and install using the oil filter wrench (3417).
8
Bolt, 15 Nm
9
Connection
10
Seal
‹› Always replace.
11
Oil Cooler
‹› See notes --> [ If metal shavings or a large quantity of small metal particles are found when repairing an engine, this could indicate that the
crankshaft and/or connecting rod bearings are damaged. To prevent further damage, perform the following steps after the repair: ] See: Engine,
Cooling and Exhaust/Engine/Engine Lubrication/Description and Operation.
‹› Ensure there is sufficient clearance to surrounding components.
‹› Removing and installing, refer to --> [ Oil Cooler ] See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Oil Cooler/Service and
Repair/Oil Cooler.
‹› Coolant hose connection diagram:
‹› With a manual transmission, refer to --> [ Coolant Hose Connection Diagram, with Manual Transmission ] See: Diagrams/Mechanical
Diagrams/Cooling System/System Diagram/Coolant Hose Connection Diagram, with Manual Transmission.
‹› With a DSG transmission, refer to --> [ Coolant Hose Connection Diagram, with DSG Transmission ] See: Diagrams/Mechanical
Diagrams/Cooling System/System Diagram/Coolant Hose Connection Diagram, with DSG Transmission.
12
Gasket
‹› Always replace.
13
Bolt
‹› Tightening sequence and specification, refer to --> [ Accessory Bracket Bolt Tightening Sequence and Specification ] See: Engine, Cooling
and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Ribbed Belt Assembly Overview.