GLI L4-2.0L Turbo (CCTA) (2008)
Information Bus: Removal and Replacement
Data Bus on Board Diagnostic Interface, Replacing
Data Bus On Board Diagnostic Interface, Replacing
-
Connect Vehicle Diagnosis, Testing and Information System VAS 5051A.
-
In Vehicle Diagnostic, Testing and Information System VAS 5051A, select operating mode "Guided Fault Finding".
-
Using the Sprung button, select "Functions/Component selection" and the following menu options in sequence:
-
Body
-
Electrical Equipment
-
01 - On Board Diagnostic (OBD) capable systems
-
Data Bus On Board Diagnostic Interface
-
Functions of Data Bus On Board Diagnostic Interface
-
Replace Data Bus On Board Diagnostic Interface
Data Bus on Board Diagnostic Interface, Removing and Installing
Data Bus On Board Diagnostic Interface, Removing And Installing
NOTE: Before removing the Data Bus On Board Diagnostic Interface J533, the codes stored in the module must always be read out.
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
Removing
-
Remove the drivers side footwell cover.