GLI L4-2.0L Turbo (CCTA) (2008)
-
Saw into heads of shear bolts so that two parallel surfaces are formed - arrows - and remove the bolts.
-
Insert a screwdriver - A - between protective housing and retaining plate - arrow -.
-
Pry protective housing upward using screwdriver - A - and pull it off sideways from retaining plate - arrow -.
-
Disengage front harness connector - 1 - from Engine Control Module (ECM) and disconnect it.
-
Pry up locking mechanism - 2 - slightly.
-
Push engine control module in direction of - arrow - out of retaining plate.
-
Release rear connector from engine control module and remove it.
Installing
-
Connect rear connector to Engine Control Module (ECM) and lock it into place.