GLI L4-2.0L Turbo (CCTA) (2008)
-
Disconnect electrical connector - 1 - on throttle valve control module J338.
-
Remove bolts - arrows - and remove throttle valve control module J338.
Installing
-
Tightening Specifications.
Installation is in reverse order. When doing this note the following:
-
Clean sealing ring surface.
-
Replace seal.
-
The rim of the sealing ring must fit into the groove provided for it inside the intake manifold.
-
If throttle valve control module J338 was replaced, then the engine control module must be adapted to the throttle valve control module J338
"Guided Function".