GLI L4-2.0L Turbo (CCTA) (2008)
/Page-59002.png)
-
Press catch - 2 - against engine control module.
-
Now connect front harness connector to Engine Control Module (ECM) and engage it.
-
Install plenum chamber bulkhead.
-
Install wiper arms and plenum chamber cover.
-
If engine control module was replaced, connect vehicle diagnostic tester and perform "Guided Function, Replacing Engine Control Module".
-
Check engine control module DTC memory erase all DTC entries "Guided Function".
NOTE: If DTC memory was erased, generate readiness code "Guided Function".
-
Perform test drive.
NOTE: Observe safety precautions that apply to road tests.
-
Again, check engine control module DTC memory.
