GLI L4-2.0L Turbo (CCTA) (2008)
-
Crimp the stripped ends of repair wire and single wire of vehicle-specific wiring harness using crimp pliers and a crimp connection as described in
chapter "Wire break with single repair point".
NOTE:
-
Make sure that crimp connections do not lie directly next to each other when several wires need to be repaired. Arrange crimp connections at a
slight offset so that the circumference of the wiring harness does not become too large.
-
In the event the repair point was previous taped, this point must be taped anew with yellow insulating tape after repairs.
-
Secure the repaired wiring harness if necessary with a cable tie to prevent flapping noises while driving.
Contacts Housings With Insulation Displacement Terminal, Repairing
Contacts Housings With Insulation Displacement Terminal, Repairing