GLI L4-2.0L Turbo (CCTA) (2008)
reinstalled after a repair.
-
Single wire seal is crimped on at the factory together with contact on the wire, this is not the case for repair wires. Single wire seal must be slid on
to wire first before crimping the repair wire.
-
Single wire seals must always fit together with wire cross-section of the repair wire used. Outer circumference of single wire seal is aligned
according to chamber circumference of the contact housing. Perform assembly using only the assembly tool with correct fit.
Assembling single wire seal:
-
Release contact lock using assembly tool with correct fit - A - and then pull wire with single wire seal toward rear - arrow - out of contact housing.