GLI L4-2.0L Turbo (CCTA) (2008)
There are 2 different distances between the ball tracks of the ball hub, a large and a small one.
-
Insert the hub with the cage and balls upright into the joint piece, a smaller space - b - must face toward the open side of the joint piece when
doing this.
-
Also observe the chamfer on the inner diameter of the ball hub which must be visible after swinging in.
-
Swing in the ball hub; to do so, swing out the hub far enough out of the cage - arrows - (as depicted in illustration).
-
Swing in the hub with the ball bearings by pressing forcefully onto the cage - arrow -.
-
CV joint, checking for function
CV joint is properly assembled, if the ball hub can be slid back and forth by hand over the whole compensation length.