volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Adjustments to be completed after replacing individual components > < Adjusting final drive

Golf Mk3

Automatic gearbox 096
Adjusting final drive
Overview of adjustments
  • Input gear
    • ◆ Adjusting
  • Drive pinion
    • ◆ Adjusting => Page 39-45
  • Differential
    • ◆ Adjusting => Page 39-52
  • Shim for input gear
    • ◆ Determine thickness on basis of table => Page 39-47
    • ◆ Determine parts number from parts catalogue
  • Shim for drive pinion
    • ◆ Determine thickness on basis of table => Page 39-47
    • ◆ Determine parts number from parts catalogue
 
V39-1381
  • Shim for differential
  • Taper roller bearings for input gear
    • ◆ Always replace together
    • ◆ Measure friction torque via pinion shaft. Friction torque of new taper roller bearings must be 180...220 Ncm greater than friction torque of pinion shaft
  • Taper roller bearings for drive pinion
    • ◆ Always replace together
    • ◆ Re-determine shim when renewing taper roller bearings
  • Taper roller bearings for differential
    • ◆ Always replace together
    • ◆ Measure friction torque via drive pinion. Friction torque of new taper roller bearings must be 60...80 Ncm greater than friction torque of drive pinion

Adjustments to be completed after replacing individual components > < Adjusting final drive