Golf Mk3
| Removing and installing upper C-pillar trim (Vento) |
| 1 - | Clip |
| q | With foam padding |
| q | Pushed in C-pillar trim mounting |
| 2 - | Clip |
| 3 - | Foam padding |
| 4 - | Trim panel |
| q | Removing: |
| – | Remove sill panel strip → Chapter. |
| – | Remove upper B-pillar trim → Chapter. |
| – | Remove cross-head screw → Item. |
| – | Pull trim off along the edge of roof and pull it out of the clips → Item at right angles. |
| – | Unhook trim from the rear shelf. |
| – | Remove lower C-pillar trim → Chapter. |
| – | Unscrew the rear anchorage for the seat belt. |
| q | Installing: |
| – | Check the seating of the clips → Item in the C-pillar and correct if necessary. |
| – | Check seating and condition of clips → Item and correct if necessary. |
| – | Check function of belt height adjustment. |
| 5 - | Adjustment lever |
| 6 - | Cover |
| 7 - | Cover |
| q | Only for vehicles without rear seat belts |
| 8 - | Cross-head screw |
