Volkswagen Workshop Service and Repair Manuals

Special tools, testers and auxiliary items

• ◆ Engine support bracket 10-222A with legs 10-222A/1
• ◆ Peening tool 3302
• ◆ Press tool VW 432

Work sequence

• ‒ Fit engine support bracket 10-222A with legs 10-222A/1.
• ‒ Locate support bracket in lifting eye on left of cylinder head and take-up weight of engine.
• ‒ Remove engine carrier.
• ‒ → Lever off washers from the spacer sleeves with pliers (replace any washers which are damaged e.g. bent washers).
• ‒ Pull out spacer sleeves and detach rubber mounting.
• ‒ Fit new rubber mounting and insert spacer sleeves as far as possible.

• ‒ → Fit washers -1- over peening tool 3302 onto the rubber mounting -2-.
• ‒ Fit press sleeve of peening tool 3302 and using a press, press the washers onto the spacer sleeves and peen. Use VW 432 as packing.
• ‒ Remove any resulting protrusion/burr on the peening.