Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Renewing panel seal >
< Zero position:
Golf Mk4
Body
General body repairs, exterior
Sliding roof
Sliding/tilting sunroof with glass panel (Webasto)
Adjusting glass panel for sliding/tilting sunroof (height adjustment)
Adjusting glass panel for sliding/tilting sunroof (height adjustment)
Adjusting glass panel for sliding/tilting sunroof (height adjustment)
Note
The glass panel height adjustment is performed after the glass panel has been closed from slide open position.
Zero position of sliding/tilting sunroof OK.
–
Tilt sunroof.
–
Slide sun blind/sliding headliner to rear.
Vehicles up to week 35/02
–
Unclip lower trim
-1-
in rear area
-arrow-
, slide forwards and take off roof frame.
–
Unclip upper trim
-2-
at front and centre and unhook at rear.
Vehicles from week 36/02
On vehicles from week 36/02, a bellows is installed in place of the upper and lower trim.
–
Disengage bellows -1- out of securing rail -3-.
–
Disengage bellows -1- at top rear out of glass panel for sliding/tilting roof -2-.
–
Unhook bellows -1- at top rear out of glass panel for sliding/tilting roof -2-.
–
Unclip bellows -1- at top rear out of glass panel for sliding/tilting roof -2-.
–
Take off bellows -1-.
Continued for all vehicles
–
Loosen securing screws
-3-
(Torx T25; 4.5 Nm).
–
Close glass panel, open panel and close again (adhere strictly to sequence to achieve a correct adjustment).
–
Carry out height adjustment of glass panel at front and rear on both sides as follows:
Panel adjustment front:
-a-
= 0…1 mm lower than roof
-Arrow-
= Forwards
Panel adjustment rear:
-b-
= 0…1 mm higher than roof
-Arrow-
= Forwards
–
Tighten screws for glass panel (4.5 Nm).
Always tighten left and right sides of glass panel symmetrically.
–
Tilt sunroof.
Vehicles up to week 35/02
–
Hook in upper trim
-2-
at rear and clip front and centre in.
–
Slide lower trim
-1-
in direction of arrow into rear elongated hole and clip front section in.
Vehicles from week 36/02
Note
t
On vehicles from week 36/02, a bellows is installed in place of the upper and lower trim.
t
Bellows and trim should not be interchanged. Clearance between mechanical parts may otherwise be impaired.
–
Engage clips of bellows -1- in glass panel for sliding/tilting roof -2-.
–
Hook bellows -1- in at top rear of glass panel for sliding/tilting roof -2-.
–
Engage bellows -1- at top rear of glass panel for sliding/tilting roof -2-.
–
Engage bellows -1- to securing rail -3-.
Body
General body repairs, exterior
Sliding roof
Sliding/tilting sunroof with glass panel (Webasto)
Adjusting glass panel for sliding/tilting sunroof (height adjustment)
Renewing panel seal >
< Zero position: