volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Adjusting locking cable > < Removing

Golf Mk4

Installing
Installing
t  Locking cable must not be kinked.
t  Adjust locking cable after installing → Chapter.
   
–  Guide locking cable between heater -3- and footwell vent -1- behind dash panel support -2-.
–  Move selector lever to “P” position.
  N37-0807
–  Pull locking cable out of cable sleeve slightly and hook into locking lever -arrow B-.
–  Hook support bracket for locking cable into selector bracket.
–  Push locking cable into steering lock → Anchor.
When doing this, make sure flattened side of locking cable is pointing downwards.
  N37-0813
–  Push on clip -2- of locking cable -3-.
Installation position:
Push on the clip from above. The angled ends of the clip face the steering lock
–  Ensure that clip is properly engaged.
–  Adjust locking cable → Chapter.
–  Check operation of ignition key removal lock → Chapter.
–  Install centre console. → Rep. Gr.68
–  Install selector lever handle → Chapter.
–  Install left trim beneath dash panel. → Rep. Gr.68
–  Install steering column trim. → Rep. Gr.70
–  Install handle for adjusting reach and height of steering column.
–  Install steering wheel and airbag. → Rep. Gr.69
–  Connect earth strap to battery.
–  Enter radio code. → Radio, telephone, navigation; Repair group 91; Radio systems
  N37-0773

Adjusting locking cable > < Removing