volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Read measured value block > < Erasing fault memory
5-speed automatic gearbox 09A self-diagnosis
Initiating basic setting
Initiating basic setting

The basic setting should be initiated after performing the following repairs:

  • ◆ Exchanging engine
  • ◆ Replacing or coding engine control unit
  • ◆ Removing and installing gearbox
  • ◆ Removing and installing "electronic accelerator"
  • ◆ Replacing automatic gearbox control unit -J217-
  • ‒ Read also:

=> "Special Information Bulletins" binder; Engine; No. 4

  • ‒ Connect fault reader V.A.G 1551 and enter address word "02 Gearbox electronics" and advance until "Select function XX" appears in the display => from page 01-23 .
 
→ Indicated on display:
Rapid data transfer      HELP
Select function XX
  • ‒ Press keys 0 and 4. (The function "Initiating basic setting" is selected with 04).

Accelerator pedal must remain in idling position.

 
→ Indicated on display:
Rapid data transfer      Q
04 - Basic setting
  • ‒ Confirm entry with key Q.
 
→ Indicated on display:
Basic setting     HELP
Enter display group number XXX
  • ‒ Press key 0, 0 and 0.
  • ‒ Confirm entry with key Q.
 
→ Indicated on display:
System in basic setting     0⇒

The system is now in the basic setting.

  • ‒ Depress accelerator pedal as far as kickdown and hold in this position for 3 seconds.
  • ‒ Press key ⇒.
 
→ Indicated on display:
Rapid data transfer      HELP
Select function XX

Read measured value block > < Erasing fault memory