Golf Mk4
Removing and installing cover for Haldex coupling from plate housing |
Special tools and workshop equipment required |
t | Pressure plate -VW 401- |
t | Pressure plate -VW 402- |
t | Press tool -VW 407- |
t | Press tool -VW 412- |
t | Extractor lever -VW 681- |
t | Centring mandrel -12 - 551- |
Special tools and workshop equipment required |
t | Drift sleeve -41 - 501- |
t | Tube -3253/1- |
t | Tube -3296- |
t | Thrust piece -T10019- |
t | Internal puller -1 - Kukko 21/2- |
t | Counter support -4 - Kukko 22/1- |
1 - | Seal |
q | For propshaft flange |
q | Renewing → Chapter |
q | Pull out with oil seal extractor lever -VW 681-. |
q | Drive in flush thrust piece -T10019-. |
2 - | Retaining ring |
3 - | Deep groove ball bearing |
q | Pressing out → Fig. |
q | Pressing in → Fig. |
4 - | Haldex coupling cover |
q | Determine according to → ETKA (electronic parts catalogue) |
5 - | Dished washer |
q | Installation position: large Ø (concave side) faces plate housing → Item |
q | Observe various versions |
q | Determine according to → ETKA (electronic parts catalogue) |
6 - | Needle thrust bearing washer |
7 - | Needle thrust bearing washer |
8 - | Needle thrust bearing washer |
9 - | Needle thrust bearing |
10 - | Needle thrust bearing |
11 - | Needle thrust bearing |
12 - | Thrust washer |
13 - | Thrust washer |
14 - | Thrust washer |
15 - | Plate housing |
q | Pressing out Haldex coupling cover → Anchor |
16 - | Needle bearing |
q | Pulling out → Fig. |
q | Pressing in → Fig. |
|
|
|
|