volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Adjusting input shaft > < Assembly overview - input shaft

Golf Mk4

Modification in springs for 5th gear synchronisation from gearbox date 05 11 1.
Modification in springs for 5th gear synchronisation from gearbox date 05 11 1.
Introduction began gradually.
   
From the above-named gearbox date, ends -A- of springs are offset.
The modified springs are installed on both sides.
–  Modified springs can be installed in earlier gearboxes only in conjunction with locking pieces which are hollow on the inside.
–  Insert locking pieces, installation position: → Fig..
  N35-0336
Installation position of springs
–  Install springs offset 120°.
–  Angled end -A- of spring must locate in hollow locking piece.
It must be located under shoulder -B- of locking piece.
+
Bent ends always face away from synchro-hub -direction of arrow-.
  N35-0337

Adjusting input shaft > < Assembly overview - input shaft