Golf Mk4
Note
|
| 1 - | Seal |
| q | Do not additionally oil or grease the oil seal sealing lip. |
| q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
| q | Renewing crankshaft oil seal - belt pulley end → Chapter. |
| 2 - | Sealing flange |
| q | Must seat on dowel sleeves. |
| q | Removing and installing → Chapter |
| q | Install with silicone sealant -D 176 404 A2- → Chapter. |
| 3 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter. |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 4 - | Flywheel/drive plate |
| q | To remove and install flywheel, counterhold with 3067 |
| q | Removing and installing drive plate → Chapter. |
| 5 - | 60 Nm + turn 90° further |
| q | Renew |
| 6 - | Intermediate plate |
| q | Must seat on dowel sleeves. |
| q | Do not damage or bend when assembling. |
| 7 - | 15 Nm |
| 8 - | Sealing flange with oil seal. |
| q | Only renew complete. |
| q | Do not additionally oil or grease the oil seal sealing lip. |
| q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
| q | Use support sleeve supplied when installing. |
| q | Only remove supporting sleeve after sealing flange has been slid onto crankshaft journal. |
