volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing crankshaft > < Loosening and tightening drive plate

Golf Mk4

Installing drive plate
Installing drive plate
   
–  Fit drive plate using packing plate with recesses -1-.
–  Fit new bolts -3- and tighten to 30 Nm.
  V13-0991
–  Check dimension -a- at three points and calculate average. Specification: 19.5…21.1 mm
  Note
Measure through hole in drive plate to milled surface of cylinder block.
If specification is not attained:
  A13-0057
–  Remove drive plate again and fit shim -2-. Tighten bolts -3- again to 30 Nm.
–  Tighten bolts to 60 Nm and turn 90° (1/4 turn) further (turning further can be done in several stages).
  V13-0991

Removing and installing crankshaft > < Loosening and tightening drive plate