volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing oil pan > < Removing and installing parts of the lubrication system

Golf Mk4

4cyl. Injection Engine, (2.0 ltr. Engine) (Mexico)
Removing and installing parts of the lubrication system
Dismantling and assembling oil filter housing
 
N17-0183
  • Sealing plug, 40 Nm
    • ◆ Renew
  • Seal
    • ◆ Fitted firmly on to -item 1-
  • Spring
    • ◆ For pressure relief valve, approx. 4 bar
  • Piston
    • ◆ For pressure relief valve, approx. 4 bar
  • Seal
    • ◆ Renew
  • Seal
    • ◆ Slide on to shoulder of sealing cover -item 7 -
  • Cover
 
N17-0183
  • Retaining clip
  • Sealing plug, 15 Nm
  • Seal
    • ◆ If sealing ring is leaking nip open and replace.
  • 1,4 bar oil pressure switch (F1), 25 Nm
    • ◆ black
    • ◆ Checking
  • Seal
    • ◆ If sealing ring is leaking nip open and replace.
  • Oil filter bracket
    • ◆ With pressed in non-return valve
  • 15 Nm + 1/4 turn (90 °) further
    • ◆ Renew
 
N17-0183
  • Seal
    • ◆ Renew
    • ◆ Clip into lugs on oil cooler
  • Oil cooler
    • ◆ Coat contact surfaces to oil filter bracket outside the seal with AMV 188 100 02
    • ◆ Ensure clearance to adjacent components
    • ◆ See note
      => Page 17-1
  • 25 Nm
  • Oil filter
    • ◆ Loosen with filter strap or oil filter key 3417
    • ◆ Tighten by hand
    • ◆ Note instructions on filter when installing

Removing and installing oil pan > < Removing and installing parts of the lubrication system