Removing and installing parts of cooling system |
Note t
| When the engine is warm, the cooling system is under pressure. If necessary, release pressure before beginning repair work. |
t
| Hoses are secured with spring-type clips. In case of repair, only use spring-type clips. |
t
| Spring-type clip pliers -VAS 5024A- are recommended for installation of spring-type clips. |
t
| When installing coolant hoses, route stress-free so that they do not come into contact with other components (observe markings on coolant connection and hose). |
Test for leaks in cooling system using cooling system tester -V.A.G 1274-, adapter for cooling system tester -V.A.G 1274/8- and adapter for cooling system tester -V.A.G 1274/9-. |
Assembly overview - parts of cooling system, body side → Chapter. |
Assembly overview - parts of cooling system, engine side → Chapter. |
Assembly overview - thermostat housing → Chapter |
Checking continued coolant circulation pump → Chapter |
Removing and installing coolant pump → Chapter. |
|
|
|