volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Immobilizer > < Removing and installing interior monitoring deactivation switch E267

Golf Mk4

Removing and installing operating mode change-over switch (petrol or gas)E382
   
Removing and installing operating mode change-over switch (petrol or gas) -E382-
The switch is fitted under the ignition switch on the driver's side of the vehicle.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
–  Unclip left-hand end piece -1- from dash panel.
  N97-0376
–  Remove securing screws -1- and unclip top of trim -2- from dash panel.
–  Remove screws -3- securing right-hand trim -4-.
–  Carefully unclip top of trim -4- from dash panel so that you can access connector of operating mode change-over switch.
  N70-0439
–  Disconnect connector -1- from switch housing -2-.
–  Push switch housing -2- forwards -arrow- out of trim.
Installing:
Install in reverse order of removal.
  N97-0377

Immobilizer > < Removing and installing interior monitoring deactivation switch E267