volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Pin assignment for ignition switch > < Removing and installing lock cylinder

Golf Mk4

Removing and installing ignition / starter switch
Removing and installing ignition / starter switch
  WARNING
To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to → Chapter.
Removing:
–  Disconnect battery → Chapter.
–  Remove steering column switch → Chapter.
–  Disconnect multi-pin connector from ignition switch.
   
–  Remove anti-tamper paint from securing screws -A-.
–  Undo securing screws -A- slightly.
–  Pull ignition switch out of steering lock housing -arrow-.
Installing:
Installation is carried out in the reverse sequence but note the following:
–  Ignition switch and lock cylinder must be installed in the same position, e.g. “ignition on”.
–  The securing screws must be resealed with locking paint.
  N94-0207

Pin assignment for ignition switch > < Removing and installing lock cylinder