volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing rain sensor G213 > < Removing and installing aerodynamic wipers

Golf Mk4

Removing and installing wiper rubber blade, aerodynamic wiper
Removing and installing wiper rubber blade, aerodynamic wiper
–  Remove aero windscreen wipers → Chapter.
–  Check to see on which the wiper rubber blade cannot be pushed into the guide.
   
–  On the side that cannot be pushed into the guide, carefully lever off the cap -1-.
  N92-10323
–  Using a suitable screwdriver open the wiper blade stop -A- by bending up.
–  Now change the wiper rubber blade (cut new blade to correct length).
  Note
t  Ensure that the rubber strip is in the correct position in the wiper blade guides.
t  Shorten wiper rubber blade to correct length.
  N92-10324
–  Push the rubber strip stop -A- back down using a suitable screwdriver until the rubber strip can no longer be moved in the guide.
  N92-10325
–  Fit the new cap -1- and check that it is properly attached.
–  Fit aero windscreen wiper blade again → Chapter.
–  Check that the wiper blade functions properly.
  N92-10326

Removing and installing rain sensor G213 > < Removing and installing aerodynamic wipers