Golf Mk5
Adjusting bonnet |
– | For initial adjustment of bonnet, -1-, the vehicle must be standing on the ground and the latch hook be removed. |
– | Remove arrester -9- → Item. |
– | Disconnect gas strut -2- at bonnet -1- → Chapter. |
– | By loosening hexagon nuts -5- and bolt -3- on both bonnet hinges -4- (do not remove) the bonnet -1- can be aligned between wings. |
– | The rear part of the bonnet -1- can be adjusted both sides to the wing height by using the adjustment screws -6-. |
– | The stop buffers -7- (Qty. 2) are not used for adjustment. They have the function of stabilising and damping the bonnet -1-. |
– | The front part of the bonnet -1- can be adjusted to wing height by using the adjustment buffers -8- (Qty. 2). |
– | Ensure that gaps are uniform → Rep. Gr.00. |
– | Carry out corrosion protection measures on hinge -4-, hexagon nuts -5- and bolts -3- following assembly or adjustment procedures. |
– | After adjusting bonnet -1-, install and adjust arrester → Item. |