Golf Mk5
Overview of selector mechanism up to 02.2009 |
1 - | Selector cover with knob |
q | Do not remove knob without reason. For emergency release, only the cover needs to be unclipped → Chapter. |
q | Right knob in figure: first pull button far enough out of knob until a small gap is visible between knob and button. Button locks in this position when released. Secure button in this position with a cable tie or wire against being pressed in. |
q | Left grip in figure: do not press button in. However, if this should happen, the knob must be dismantled and prepared for installation → Chapter. |
2 - | Selector lever and selector mechanism |
q | With selector lever lock solenoid -N110- |
q | Emergency release → Chapter. |
q | Brief instructions for removing and installing: |
– | Remove centre console. |
– | Remove cable from gearbox and separate selector mechanism → Chapter. |
– | If necessary, disconnect or remove parts of → exhaust system; Rep. gr.26. |
– | Remove heat shield beneath vehicle. |
– | Adjust selector lever cable after installing → Chapter. |
3 - | Bolt with spring |
q | 3 Nm |
4 - | Pin |
q | Removing → Chapter |
q | Do not grease |
5 - | Securing clip |
q | Always renew after removing |
6 - | Nut |
q | 9 Nm |
q | Qty. 4 |
7 - | Selector lever housing |
q | With seal |
8 - | Selector lever cable |
q | Cable must not be greased |
q | Removing and installing → Chapter |
q | Checking → Chapter |
q | Adjusting → Chapter |
9 - | Securing clip |
q | Always renew after removing |
10 - | Securing clip |
q | Always renew after removing |
11 - | Hexagon nut with washer |
q | 8 Nm |
q | Qty. 4 |