Volkswagen Workshop Service and Repair Manuals

Removing LHD –  First check whether a coded radio is fitted. If so, obtain anti-theft code. –  Remove battery and, if necessary, detach backwall of battery box → Electrical system; Rep. gr.27. Right-hand drive

–  In vehicles with petrol engine, remove air pipe -arrow- → Rep. gr.21.

–  In vehicles with particle filter, remove shielding -A- from particle filter → Rep. gr.26. Continuation for all RHD vehicles

An insulation mat is installed in conjunction with some engines. Appearance may be different from that illustrated. –  Remove heat shield mat -arrows- (if fitted).

In some vehicles, clutch position sender -G476- is located behind a line for air conditioning system -arrow-.

Continuation for all If a line -1- with a round component is installed directly beneath the master cylinder, the line must be removed.   Note During the following work, ensure that no brake fluid lands on longitudinal member or gearbox. If this does happen, clean the affected areas thoroughly.

–  Clamp off supply hose to master cylinder using hose clamp -3094-.

–  Release securing clip -2- with a screwdriver or a pointed object and pull out of master cylinder to stop. –  Pull line -1- out from master cylinder and seal hose. –  Unclip clutch position sender -G476- from master cylinder -arrow- and remove. –  Disconnect electrical connector -4-.