volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing clutch position sender G476

Golf Mk5

Removing
Removing
–  First check whether a coded radio is fitted. If so, obtain anti-theft code.
–  With ignition switched off, disconnect battery → Electrical system; Rep. Gr.27.
–  Remove complete air filter housing → Rep. Gr.23 or → Rep. Gr.24.
–  Remove battery and battery tray → Electrical system; Rep. Gr.27.
   
If a pipe/hose line or plastic line -1- with a round component is installed directly beneath the master cylinder, the pipe/hose line or plastic line must be removed.
  Note
During the following work, ensure that no brake fluid lands on longitudinal member or gearbox. If this does happen, clean the affected areas thoroughly.
  N30-10122
–  Clamp off supply hose to master cylinder using hose clamp -3094-.
  A30-0127
–  Release securing clip -2- with a screwdriver and pull out of master cylinder to stop.
–  Pull pipe/hose line or plastic line -1- out from master cylinder and seal hose.
All vehicles
–  Disconnect electrical connector -4-.
–  Unclip clutch position sender -G476- from master cylinder -arrow- and remove.
  N30-10122

Installing > < Removing and installing clutch position sender G476