volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Torque settings > < Removing

Golf Mk5

Installing
Installing
Install in the reverse order of removal, observing the following:
  Note
Renew self-locking nuts.
   
–  Attach retainer -2- to master cylinder operating rod -1-.
–  Press retainer into notch in clutch pedal -3- until it can be heard to engage.
  A30-0133
–  Insert over-centre spring -2- in mounting bracket from above while holding end of spring with assembly tool -T10178- in installation position.
–  Insert tip of clutch pedal -1- in bearing recess of over-centre spring.
–  Depress clutch pedal slightly, push bolt through and tighten self-locking nut.
  A30-0126
–  Now bolt on crash bar -1- in front of clutch pedal -2- → Chapter.
–  Install trim and cover below trim on driver side. → Rep. Gr.68
  N34-10315

Torque settings > < Removing