volkswagen Workshop Repair Guides

Volkswagen Golf Workshop Service and Auto Repair Manuals

ABOUT US
Torque setting > < Repairing selector mechanism, gearbox side

Repairing and Renewing Oil Seal for Selector Shaft in Gearbox Side

Renewing oil seal for selector shaft
Renewing oil seal for selector shaft
Special tools and workshop equipment required
   
t  Tube -VW 423-
  W00-0140
t  Oil seal extractor lever -T20143/1-
t  Sealing grease -G 052 128 A1-
–  Remove complete air filter housing if it is over selector shaft → Rep. Gr.23 or → Rep. Gr.24.
Metal relay lever
  W00-2958
–  Pull off securing clip -2- and press relay lever -3- to side out of mounting.
  Note
If relay lever cannot be removed due to gearbox bracket, remove gate selector cable from relay lever. Guide shoe out of gearbox selector lever.
Plastic relay lever
–  Remove relay lever together with cable end-piece → Chapter.
Continued for all selector mechanisms
–  Remove nuts -4- and remove gearbox selector lever -1-.
  A34-0634
–  Lever out seal using oil seal extractor lever -T20143/1-.
  A34-0635
–  Lightly oil outer circumference of new oil seal.
–  Fill space between sealing lip and dust lip -arrow- with sealing grease -G 052 128 A1-.
  N32-0001
–  Drive in seal to stop using tube -VW 423-.
Carry out further installation in the reverse sequence noting the following points:
  Note
The gearbox selector lever can be installed in only one position.
–  If complete air filter housing was removed, install it. → Rep. Gr.23 or → Rep. Gr.24.
  A34-0636

Torque setting > < Repairing selector mechanism, gearbox side