volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Torque settings > < Removing

Golf Mk5

Installing
Installing
Install in the reverse order of removal, observing the following:
   
Some cars have damping -arrow- on the clutch pedal mounting bracket.
  Note
t  Renew self-locking nuts.
t  Renew hose clips.
t  Allocate all components according to → Electronic parts catalogue “ETKA”.
The crash bar -1- in front of clutch pedal -2- may be secured in different ways.
Attachment with 2 bolts
  N30-10195
–  Install crash bar -1- and tighten the 2 bolts to specified torque → Chapter.
Attachment with 1 bolt
  N34-10315
–  Install crash bar -1- and tighten bolt -2- to specified torque → Chapter.
–  Install trim and cover below trim on driver side → Rep. Gr.68.
  N30-10117
–  Push pipe/hose line -1- with seal -2- onto connection of master cylinder -4- until securing clip -3- engages audibly.
–  Test pipe/hose line by tugging on it.
–  After removing hose clamp -3094-, return supply hose to its original position, if necessary.
–  Bleed clutch system → Chapter.
–  Install battery → Electrical system; Rep. Gr.27.
–  Install complete air filter housing → Rep. Gr.24.
  A30-0130

Torque settings > < Removing