volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Torque settings > < Removing

Golf Mk5

Installing
Installing
Install in the reverse order of removal, observing the following:
  Note
Renew self-locking nuts.
   
–  Insert over-centre spring in mounting bracket from above while holding end of spring with release tool -T10178- in installation position.
  A30-0126
–  Receptacle -arrow- for tip -A- of clutch pedal must stand vertically.
–  Insert tip of clutch pedal in bearing recess of over-centre spring.
–  Depress clutch pedal slightly, push bolt through and tighten self-locking nut.
  N30-0421
Some cars have damping -arrow- on the clutch pedal mounting bracket.
–  Return it to installation position.
The crash bar -1- in front of clutch pedal -2- may be secured in different ways.
Attachment with 2 bolts
  N30-10195
–  Install crash bar -1- and tighten the 2 bolts to specified torque → Chapter.
Attachment with 1 bolt
  N34-10315
–  Install crash bar -1- and tighten bolt -2- to specified torque → Chapter.
–  Install trim and cover below trim on driver side → Rep. Gr.68.
  N30-10117

Torque settings > < Removing