Volkswagen Workshop Service and Repair Manuals > Golf Mk5 > Power transmission | 6-speed manual gearbox 0AJ | Gearbox mechanics,operation, construction,diff. | Gearbox housing cover

Repairing gearbox housing cover

Special tools and workshop equipment required

t	Press tool -VW 412-

t	Drift sleeve -40-21-

t	Support bridge -2011-

t	-1-Internal puller -Kukko 21/5-

t	-4-Counter support -Kukko 22/2-

t	e.g. hot-air blower -V.A.G 1416-

Pulling cylindrical roller bearing out of gearbox housing cover

A -	Internal puller, 28…37 mm, e.g. -Kukko 21/5-

B -	Counter support, e.g. -Kukko 22/1-

Pressing cylindrical roller bearing into gearbox housing cover

–	Heat gearbox housing cover with, for example, hot air blower -V.A.G 1416- to about 100°C in vicinity of bearing seat.

–	Insert cylindrical roller bearing in heated housing and press in using workshop press until heat exchange has taken place.

Note

Cylindrical roller bearings must be pressed into cover to stop. Do not use mounting plate to press bearings by tightening bolts.

Volkswagen Workshop Service and Repair Manuals