Golf Mk5
| Assembly overview - selector forks |
Note| It is not necessary to dismantle the selector fork group in order to dismantle and assemble selector segments, lock washers and angular contact ball bearings. |
| 1 - | Selector fork group with selector plate |
| 2 - | Selector segment for 3rd and 4th gear |
| q | Identification → Fig. |
| q | After installation, selector segment must still rotate freely |
| 3 - | Angular contact ball bearing |
| q | Qty. 4 |
| q | Removing → Fig. |
| q | Press inner race into outer race → Fig. |
| q | Installing → Fig. |
| 4 - | Lock washer |
| q | Always renew |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 5 - | 1st/2nd gear selector segment |
| q | Identification → Fig. |
| q | After lock washer is installed, segment must still rotate freely |
| q | Selector fork with selector segment → Fig. |
| 6 - | Selector fork for 5th and 6th gears with selector segments |
| q | Selector segment is permanently connected to selector fork. |
| q | Identification → Fig. |
| 7 - | Pivot pin |
| q | For selector fork for 5th and 6th gears |
