Golf Mk5
Assembly overview - selector lever and selector housing (up to 10.06) |
Note
t | Lubricate bearing positions and sliding surfaces. |
t | Allocate grease using → Electronic parts catalogue (ETKA). |
1 - | Securing clip |
q | Removing and installing → Fig. |
2 - | Bush |
3 - | Compression spring |
4 - | Bush |
5 - | Torx bolt, 5 Nm |
6 - | Cover |
7 - | Damping |
8 - | Damping |
9 - | Ball socket |
10 - | Gear lever guide |
11 - | Damping washer |
12 - | Seal |
q | Between selector housing and underbody |
q | Self-adhesive |
q | Bond to selector housing |
13 - | Selector lever |
14 - | Selector housing |
15 - | Bearing bush |
16 - | Pivot pin |
17 - | Guide bush |
18 - | Compression spring |
q | Installing → Fig. |
19 - | Gate selector lever |
20 - | Torx bolt, 5 Nm |
21 - | Seal |
q | Always renew |
22 - | Base plate |
q | Bend open tabs to remove |
q | Always renew |
23 - | Gate selector cable |
q | On gate selector lever |
q | Removing and installing → Fig. |
24 - | Gear selector cable |
q | Removing from and attaching to gear lever guide → Fig. |
25 - | Securing clip |
q | Always renew |
26 - | Hexagon nut M8, 25 Nm, hexagon nut M 6, 8 Nm |
q | Qty. 4 |
27 - | Bearing bush |
q | Fits in one position only |
28 - | Securing clip |
q | Always renew |
|