volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing poly V-belt > < Assembly overview - poly V-belt drive

Golf Mk5

Removing poly V-belt
Removing poly V-belt
Special tools and workshop equipment required
   
t  Locking pin -T10060 A-
  W00-10235
t  16 mm open-end spanner -T 10241-
–  Remove noise insulation. → General body repairs, exterior; Rep. gr.50.
–  Remove lower part of front right wheel housing liner → General body repairs, exterior; Rep. gr.66.
  WARNING
t  The fuel and the fuel lines in the fuel system can become very hot (danger of scalding)!
t  The fuel system is also under pressure! Before opening the system, place cloths around the connections. Then carefully loosen connection to release the pressure!
t  Wear eye and hand protection when performing any type of repair work on the fuel system!
–  Golf, Golf Plus, Touran: Pull fuel filter out of bracket and place it with hoses to one side.
  W00-10100
–  Only Passat: Separate push-fit couplings of fuel lines -arrows-.
  Note
Do this by lifting catch of push-on connectors.
All other vehicles continued
–  Unbolt fuel filter from engine assembly mounting and lay to side (hoses remain connected).
–  Mark direction of rotation of poly V-belt.
–  Swing tensioning element in direction of arrow to remove tension from poly V-belt.
  N15-10019
The open-end spanner 16 mm -T 10241- is particularly well suited to relieve tension.
  A13-0083
–  Lock tensioning element using locking pin -T10060 A-.
–  Remove poly V-belt.
  N13-10135

Installing poly V-belt > < Assembly overview - poly V-belt drive