Volkswagen Workshop Service and Repair Manuals > Golf Mk5 > Power unit | 4-cylinder diesel engine (1.9 l engine) | Fuel preparation system Diesel injection | Engine control unit | Reading and clearing engine control unit fault memory

Reading and clearing engine control unit fault memory

Special tools and workshop equipment required

t	Vehicle diagnostic, testing and information system -VAS 5051-

–	Connect vehicle diagnostic, testing and information system -VAS 5051- as follows:

–	Push diagnosis cable connector onto diagnosis connector.

–	Start engine and run at idling speed.

Only when engine does not start:

–	Switch on ignition.

Select operating mode

–	Press button on display for „Vehicle self-diagnosis“.

Select vehicle system

–	Press button „01 - Engine electronics“ on display.

The control unit identification and engine control unit coding are indicated on display.

Select diagnostic function

–	Press button „02 - Read fault memory“ on display.

–	If no fault is stored in engine control unit „0 fault detected“ is displayed.

–	If faults are stored in the engine control unit, these are shown one below the other on the display.

–	Press the ← button.

–	Press button „05 - Clear fault memory“ on display.

–	Press function „06-End output“.

Volkswagen Workshop Service and Repair Manuals