volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing, installing and tensioning toothed belts > < Removing

Golf Mk5

Installing
Installing
Installation is carried out in the reverse sequence of removal. When doing this, note the following:
  Note
t  Renew cylinder head cover gasket and seal for bolts if damaged.
t  The cylinder head cover gasket can be renewed only together with the cylinder head cover.
   
–  Place a drop of sealant -AMV 174 004 01- (Ø approx. 5 mm) -arrows- on edges of both sealing surfaces of bearing cap and cylinder head at front of engine.
  A15-0520
–  Place a drop of sealant -AMV 174 004 01- (Ø approx. 5 mm) -arrows- on edges of both sealing surfaces of bearing cap and cylinder head at rear of engine.
  A15-0521
–  Screw on cylinder head cover hand tight in the sequence -1 to 13.-
–  Tighten bolts to 10 Nm in the sequence 1 to 13.
  N15-10027

Removing, installing and tensioning toothed belts > < Removing