volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing oil sump

Golf Mk5

Removing
Removing
–  Remove sound insulation tray → General body repairs, exterior; Rep. Gr.50.
–  Drain engine oil.
  Note
Observe environmental regulations for disposal.
–  Pull 3-pin connector off oil level and oil temperature sender -G266-.
–  Remove oil sump.
–  Loosen oil sump with light blows of a rubber headed hammer if necessary.
–  Remove sealant residue on cylinder block with a flat scraper.
   
–  Remove sealant residue on oil sump with a rotating brush, e.g. a hand drill with a plastic brush (wear protective glasses).
–  Clean sealing surfaces. They must be free of oil and grease.
  N17-0012

Installing > < Removing and installing oil sump