Golf Mk5
| Assembly overview - oil pump, sump |
| 1 - | 15 Nm |
| 2 - | Sealing flange |
| q | With seal. |
| q | Must be positioned on dowel sleeves. |
| q | Removing and installing → Chapter. |
| q | Install with silicone sealant -D 176 404 A2-. |
| q | Do not additionally oil or grease the oil seal sealing lip. |
| q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
| 3 - | Chain tensioner with tensioning rail, 15 Nm |
| q | When installing, pretension spring and fit. |
| 4 - | Oil dipstick |
| q | The oil level must not be above the max. mark! |
| q | Markings → Chapter. |
| 5 - | Dipstick guide |
| 6 - | Guide tube |
| 7 - | Dowel sleeves |
| 8 - | O-ring |
| q | Renew. |
| 9 - | 15 Nm |
| 10 - | Suction line |
| q | Clean strainer if soiled. |
| 11 - | Baffle plate |
| 12 - | 15 Nm |
| 13 - | 15 Nm |
| 14 - | Oil sump |
| q | Removing and installing → Chapter. |
| q | Clean sealing surface before fitting. |
| q | Install with silicone sealant D 176 404 A2. |
| 15 - | Oil drain plug, 30 Nm |
| q | Renew. |
| 16 - | 10 Nm |
| 17 - | Oil level and oil temperature sender -G266- |
| q | Black connector, 3-pin. |
| q | Check → Vehicle diagnostic tester. |
| 18 - | Seal |
| q | Renew. |
| 19 - | Oil pump |
| q | With 12 bar pressure relief valve. |
| q | Before installing, check that both dowel sleeves for centring oil pump on cylinder block are fitted. |
| q | Renew if running surfaces and gears are scored. |
| 20 - | Chain sprocket for oil pump |
| 21 - | Retainer |
| q | For oil level and oil temperature sender -G266- wiring harness. |
| 22 - | 20 Nm + 1/4 turn (90°) further |
| 23 - | Chain |
| 24 - | 25 Nm |
| q | Insert without sealant. |
| 25 - | Oil spray jet |
| q | For piston cooling. |
