–
| Cut off tube nozzle at forward marking (Ø of nozzle approx. 3 mm). |
–
| Apply silicone sealing compound, as shown, to clean sealing surface on sump. Sealing compound bead must be: |
t
| Run bead along inner side of bolt holes -arrows-. |
Note The sealing compound bead must not be thicker, otherwise excessive sealing compound will enter the sump and may block the oil suction pipe strainer. |
–
| Install sump immediately and tighten all sump bolts lightly. |
–
| Tighten oil sump bolts to 13 Nm. |
Note Let sealing compound dry for approx. 30 minutes after installing sump. Only then fill with engine oil. |
|
|
|