Volkswagen Workshop Service and Repair Manuals > Golf Mk5 > Power unit | 4-cylinder injection engine (1.4 and 1.6 l direct injection) | Enginecrankshaft group, pistons | Sealing flange and flywheel or drive plate | Removing and installing engine speed senderG28

Removing and installing engine speed senderG28

Removing and installing engine speed sender -G28-

Special tools and workshop equipment required

t	Special wrench, long reach -T10370-

Removing

Engine speed sender is located under intake manifold on crank shaft sealing flange on flywheel end.

–	Pull off connector -1- from engine speed sender -G28-.

–	Remove gasket -2- from cylinder block and remove engine speed sender -G28- with socket -T10370-.

Installing

–	Install engine speed sender -G28- and tighten securing bolt to 5 Nm.

Further assembly is basically the reverse of the dismantling sequence.

Volkswagen Workshop Service and Repair Manuals